Cooper i-On 40 Manual do Utilizador

Ethernet Communications Module Installation and Operation InstructionsService InformationS225-40-8October 2012 • Supersedes 08/091Voltage RegulatorsSe

Ethernet Communications Module Installation and Operation Instructions10 5. Select TCP/IP (Network) from the connection type dropdown. 6. In the Man

11S225-40-8!SAFETYFOR LIFE 7. To start communications click on the Connect button. 8. Select the port that has just been created and select Connect to

Ethernet Communications Module Installation and Operation Instructions12APPENDIx ASetting the IP Address of an Ethernet Card When it is UnknownThis pr

13S225-40-8!SAFETYFOR LIFE6. You can confirm that the temporary IP assignment occurred by typing the command Arp –a at the command prompt. If the ass

Ethernet Communications Module Installation and Operation Instructions14 7. At the command prompt type Telnet xxx.xxx.xxx.xxx1 where xxx is the IP a

15S225-40-8!SAFETYFOR LIFE10. Type in the four parts of the new IP address at the prompt and hit enter after each. In this case the default IP address

Ethernet Communications Module Installation and Operation Instructions16©2012 Cooper Industries. All Rights Reserved.Cooper Power Systems and ProView

Ethernet Communications Module Installation and Operation InstructionsThe instructions in this manual are not intended as a sub stitute for

S225-40-8!SAFETYFOR LIFEIntroductionService Information S225-40-8 provides the installation and operation instructions for a CL-6 series reg

Tools and Additional Accessories RequiredStandard Screw DriverEthernet Communications Module Installation and Operation Instructions4INSTALLATION PROC

S225-40-8!SAFETYFOR LIFE 5. Connect 115 Vac power to the three-position terminal block on the right-hand side of the communication module. Us

9. Push the interface cable terminal connector into an open accessory jack on the side of the control panel (on CL-6 controls, the hinge s

S225-40-8!SAFETYFOR LIFECONFIGURATION / OPERATIONThe Ethernet module must be configured before it can be accessed on the network. The CL

Ethernet Communications Module Installation and Operation Instructions8 6. Simply hit OK, and the Welcome Screen will appear. Click on Basic Settings

9S225-40-8!SAFETYFOR LIFEConfiguring ProView NXG™ Software to Communicate with the CL-6 Control via Ethernet Card 1. Connect your computer to the Eth