Cooper i-On 40 Manual do Utilizador descarregar pdf (Página 14)

Ethernet Communications Module Installation and Operation Instructions

7. At the command prompt type Telnet xxx.xxx.xxx.xxx1 where xxx is the IP address temporarily assigned in Step 5.

This command should time out almost immediately and it will indicate that the connection failed.

8. At the command prompt type Telnet xxx.xxx.xxx.xxx 9999 where xxx is the IP address temporarily assigned in Step 5.

This command will run through a number of lines and end up with the prompt to Press Enter for the Setup Mode. Within

3 seconds of the command being executed, press enter to go into the Setup Mode.

9. Type in 0 to select Server and hit enter.

1 2 ... 9 10 11 12 13 14 15 16

Sem comentários

Cooper i-On 40 Manual do Utilizador Página 14