Cooper Menvier 100 Informações Técnicas descarregar pdf (Página 18)

Installation

Wiring Hints

• Each terminal is suitable for clamping up to 2 wires.

• Clamping of 2 wires of very different diameters

under one screw is not commended.

• Suitable for mounting to mounting boxes with

50-80mm fixing centres.

General

If difficulty is experienced when mounting the

detector, this may be due to the following:

• Wiring causing an obstruction - move or shorten

wires.

• Although the base is tolerant to uneven mounting

surfaces, a very uneven surface may cause the

base to deform when the mounting screws are

tightened down - loosen screws to reduce this

or slide base to a more flat position.

Utilising Locking Tab

Mounting base includes an optional feature to prevent

the removal of the detector without the use of a tool.

1. Remove the standard fit retaining clip.

2. Insert the locking clip which is located at the centre

of the base as shown.

Mount the detector onto the base and rotate fully

clockwise until it finally clicks.

The detector is now locked into position. Remove by

utilising a suitable tool (eg a thin screwdriver) into the

hole in the detector cover. Gently push the tool into

the detector and rotate anticlockwise.

Warning!

Do not use high voltage testers when detectors or

control panel are connected to the system.

Dimensions

Dia

Description Dia (mm) D (mm)

Detector Base 102 22

Wide Base 158 22

Code Description

CB2E Detector Base

CB Wide Detector Base

Product Codes

CB2E & CB - Conventional Detector Bases

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Sem comentários

Cooper Menvier 100 Informações Técnicas Página 18