Cooper TS590 Instruções de Operação descarregar pdf (Página 7)

Unsetting the system

The unsetting of the alarm system can be performed at any remote keypad.

1. Enterthepremisesviatheprescribed

entry route and proceed directly to

the remote keypad. The internal

sounders generate an interrupted

tone. The display will show the

remaining entry time.

2. Enter your 4 digit passcode before

the entry timer expires. The internal

sounderswill stop and the display will

show“SYSTEMOPEN”.After5seconds

the “SYSTEM OPEN” message will

disappear and the display will show

thetime,(dateandbannertext,LCD

only).

If the entry time is exceeded an alarm is generated from the internal

soundersandthe“SecondEntry”timerisstarted.Ifattheendofthe“Second

Entry” timer the alarm system has not been unset a full alarm condition will

occur.Ifthealarmcompanyhassetthe“SecondEntry”timertozerothefull

alarm will occur when the first entry timer expires.

Ifduringtheentryproceduretheuser strays fromtheprescribedentryroute

and activates a detection circuit a full alarm will occur (internal sounders

and external sounders). If the alarm system is fitted with a remote signalling

device this will also be triggered.

The alarm system can be programmed with an “Abort” feature which will

allow the system totransmit anabort signalto youralarm receivingcentre.

On receiving this signal your alarm receiving centre will cancel any police

action. This feature is controlled by a time delay (normally set to 90

seconds). Following a full alarm condition you must enter your passcode

withthis time period in orderto send theabort signal, ifyou fail toenter your

passcode before the timer expires police action will be taken.

SYSTEM OPEN

17:30 01 JAN

Enter Your Code

Time left > 0015

? ? ? ?

LCD Remote

NOTES

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Sem comentários

Cooper TS590 Instruções de Operação Página 7