Cooper M3000 Guia do Utilizador descarregar pdf (Página 333)

Chapter 8 Upgrade of XSCF Firmware and Maintenance 8-17

Note – In a system with redundant XSCF Units:

i) Perform the firmware update in order, beginning with the standby side and then the active

side automatically. After the update on the standby side is completed, the active and standby

sides are switched. At this time, the XSCF reset is done and the XSCF session is

disconnected.

ii) Re-connect the XSCF and log in again.

iii) XSCF firmware update is completed.

iv) To switch the XSCF, select [Utility]-[Switch Over].

d. Refer to the Monitor message log to confirm that the XSCF firmware update has

finished.

6. To complete the update of the OpenBoot PROM firmware, restart the domain.

7. Confirm that the version of the system firmware that is running is that of the

firmware applied from the XSCF Web console.

Updating XCP From External Media

1. Insert the external media with the XCP file into the drive. Insert the external media

into a drive connected to the network that XSCF has access to. If necessary, copy the

XCP file to an arbitrary folder.

2. Confirm the XCP version in the XCP file (tar.gz) of external media. The latest XCP

information is released on external media or a web site. To obtain the URL of the

web site, see the description of the firmware download in the Product Notes for your

server.

3. Perform the same steps in Updating XCP From the Network.

Confirming That the OpenBoot PROM Firmware is Updated When a

CMU/MBU Is Added or Replaced

Note – This function is not available when you are using the M3000 server. When a MBU

is replaced, you must match the number of the firmware versions. See Confirming That the

XSCF Firmware Is Updated When the MBU Is Replaced (in the M3000 server)

1 2 ... 328 329 330 331 332 333 334 335 336 337 338 ... 431 432

Sem comentários

Cooper M3000 Guia do Utilizador Página 333